Found Code P1101, Checked throttle data, found idle data above threshold. Removed and cleaned throttle body, reset throttle idle learn. Test drove. No code has returned. Needs to be driven more to verify its been corrected. If light returns, we may need to replace throttle body.
MICHELLE C. gave our service a 5 star review on 2/23/2023
SHORT BLOCK – Remove & Replace – 1.5L Eng – [Includes: R&I Bumper Cover. Includes: Recover, Evacuate and Recharge Air Conditioning System. DOES NOT include wheel alignment.] – [Consists of a Cylinder Block fitted with Pistons, Rings, Connecting Rods, Cran
Michelle C. gave our service a 5 star review on 4/11/2022
Diagnose poor shifting Customer states hard shift during second shift after trans is warm. Check mounts for possible movement that could cause a hard shift feeling.
CHECK SYSTEM FOR PROPER OPERATION
VEHICLE INSPECTION
Torque Wheels
Check and correct tire pressures
CONTROL ARM – Remove & Replace – Lower,Both – [DOES NOT include alignment.]
ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine,Both
ENGINE TORQUE MOUNT – Remove & Replace – Strut
ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Trans,Rear,Left Side of Engine Compartment
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
(Combination) – DISC ROTOR (REMOVED) – Refinish Each Additional
For details go to: https://motorist.digital/l/KNF2hj Technician: Paul Buie
Mike C. gave our service a 5 star review on 2/22/2022
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
TIE ROD &/OR END – Remove & Replace – 1500,Rack & Pinion Type Gears Inner,Both – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion
Alignment
TRANSMISSION FLUID EXCHANGE
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Eric M. gave our service a 5 star review on 9/29/2021