JSON-LD markup generated by Google Structured Data Markup Helper.

Call (702) 568-7226

Go to…

Mazda

Home / Mazda

We Service and Repair all Mazda cars

  • 2016 Mazda CX-5

    Mazda CX-5
    Mileage
    64,877
    Service Date
    8/29/2024
    Services Performed
    • VEHICLE INSPECTION
    • Check and correct tire pressures
    • Torque Wheels to proper specification
    • Double check wheel torque – verified by another associate
     
    Donna K. gave our service a 5 star review on 8/29/2024

  • 2009 Mazda 3

    Mazda 3
    Mileage
    139,584
    Service Date
    2/17/2023
    Services Performed
    • Check fuel pump for leak
    • VEHICLE INSPECTION
    • Torque Wheels
    • Check and correct tire pressures
    • FUEL PUMP – Remove & Replace – Normally Aspirated Main,Assembly
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Normally Aspirated Engine
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Normally Aspirated Transaxle,Rear
    • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both Sides. – [DOES NOT include disassemble or alignment.]
    • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
    • POWER STEERING HOSE – Remove & Replace – Normally Aspirated Pressure Hose – [Includes: Bleed System.]
    • Courtesy Alignment
     
    James T. gave our service a 5 star review on 2/17/2023

  • 2012 Mazda 3

    Mazda 3
    Mileage
    67,023
    Service Date
    9/28/2022
    Services Performed
    • Found engine light not on at this time. Scanned PCM and found code for fuel system lean P0171.EVAP leak very small P0456. Inspect MASS air sensor and found heavily coated with dust and debris. Cleaned MASS air and allowed to dry for 30 min. Preformed vacuum test on purge solenoid and found held vacuum for 20min. Preformed smoke test 3 times. Verified vent valve operating. Did find vent filter to have heavy dust coverage. EVAP passed leak test. Cleared memory of PCM and test drove to set monitors. Completed monitors on test drive.
    • Cleaned Mass airflow sensor, long test drive to set monitors
    • VEHICLE INSPECTION
    • Torque Wheels
    • Check and correct tire pressures
    • AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Normally Aspirated Left – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
     
    Andrea W. gave our service a 5 star review on 9/28/2022

  • 2006 Mazda 5

    Mazda 5
    Mileage
    71,381
    Service Date
    4/3/2021
    Services Performed
    • $25 off complete brake service
    • Battery Replacement
    • Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
    • Clock, brake shimmy, possible trans issue, rough idle
    • DISC ROTOR – Remove & Replace – Rear,Both Sides. – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
    • ENGINE OIL COOLER – Remove & Replace
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Engine
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Transaxle,Rear
    • ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Transaxle,Right Side,(Rear)
    • For details go to: https://motorist.digital/l/BuP4Rh Technician: Matt Connerty
    • Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
    • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
    • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both Sides. – [DOES NOT include disassemble or alignment.]
    • SPARK PLUGS – Remove & Replace
    • Torque Wheels
    • TRANSMISSION FLUID EXCHANGE
    • TURN SIGNAL SWITCH – Remove & Replace
    • VEHICLE INSPECTION
    • Wiper blades
     
    MIKE T. gave our service a 5 star review on 4/3/2021

  • 2008 Mazda CX-9

    Mazda CX-9
    Mileage
    1
    Service Date
    3/10/2021
    Services Performed
    • ALTERNATOR DRIVE BELT – Remove & Replace – [Includes: Serpentine type Belt(s).]
    • DETERMINE CAUSE
    • For details go to: https://motorist.digital/l/B7pDUZ Technician: Matt
    • STOP LIGHT SWITCH – Remove & Replace
    • Torque Wheels
    • VEHICLE INSPECTION
    • Verify engine noise when starting in the morning
    • Key cut and programming
     
    AL T. gave our service a 5 star review on 3/10/2021

  • 2011 Mazda 3

    Mazda 3
    Mileage
    103,137
    Service Date
    12/17/2019
    Services Performed
    • ENGINE OR TRANSAXLE MOUNT – Remove & Replace – Lower at Engine/Transaxle
    • ENGINE OR TRANSAXLE MOUNT – Remove & Replace – Right Side of Engine Compartment
    • VEHICLE INSPECTION
     
    LIZZY M. gave our service a 5 star review on 12/17/2019